Dataman 40Pro User Manual download pdf (Page 57)

DATAMAN-MEMPRO

Power supply connector



Connecting DATAMAN-MEMPRO to PC

For DATAMAN-MEMPRO order of connecting USB cable and power supply to programmer is

irrelevant.

Problems related to the DATAMAN-MEMPRO



interconnection, and their removing

If you have any problems with DATAMAN-MEMPRO PC interconnection, see section

Common notes please.

Manipulation with the programmed device

After selection of desired device for your work, you can insert into the open ZIF socket (the

lever is up) and close socket (the lever is down). The correct orientation of the programmed

device in ZIF socket is shown on the picture near ZIF socket on the programmer's cover. The

programmed device is necessary to insert into the socket also to remove from the socket

when LED BUSY light off.

Warning: DATAMAN-MEMPRO programmer hasn’t protection devices, which protect the

content of programmed device against critical situations, for example power failures and PC

failure (interrupted cable...). Moreover, a device is usually destroyed in the programming

mode due to forced interruption of the control program run (Reset or switching the computer

off) due to removing the connecting cable, or unplugging the programmed device from the

ZIF socket. Incorrectly placed device in the ZIF socket can cause its damage or destruction.

Selftest

If you feel that your programmer does not react according to your expectation, please run the

programmer selftest using Diagnostic POD, enclosed with the standard delivery package.

 Insert 40 pins diagnostic POD - type I into ZIF socket of the programmer. 40 pins

diagnostic POD - type I must be inserted as 40 pins device.

 Run selftest of programmer in PG4UW (Programmer / Selftest plus).

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 173 174

No comments

Dataman 40Pro User Manual Page 57