Dataman 40Pro User Manual download pdf (Page 20)

7) power supply connector

8) power switch

9) "GND" connector can be used for grounding of the programmer

"ESD wrist strap" connector is place for attaching of ESD wrist strap

10) temperature controlled fans

11) type B USB connector for PC  DATAMAN-448PRO2 communication cable

Manipulation with the programmed device

After selection of desired device for your work, you can insert it into the open ZIF socket (the

lever is up) and close socket (the lever is down). The correct orientation of the programmed

device in ZIF socket is shown on the picture near ZIF socket on the programmer's cover. The

programmed device is necessary to insert into the socket also to remove from the socket

when LED BUSY light off.

Note: Programmer's protection electronics protect the target device and the programmer

itself against either short or long-term power failures and, partly, also against a PC failure.

However, it is not possible to grant the integrity of the target device due to incorrect, user-

selected programming parameters. Target device may be not destroyed by forced interruption

of the control program (reset or switch-off PC), by removing the physical connection to the

programmer, but the content of actually programmed cell may remains undefined. Don't

unplug the target device from the ZIF socket during work with devices (LED BUSY shine).

In-system serial programming by

DATAMAN-448PRO2

Optimized advanced pindriver deliver programming performance without overshoot or ground

bounce for all device technologies. Pin drivers operate down to 1.8V so you'll be ready to

program the full range of today's advanced low- voltage devices.

The ISP programming solution performs programming verification at the marginal level of

supply voltage, which, obviously, improves programming yield, and guarantees long data

retention.

The ISP programming solution provides also the power supply for the target system.

The software provide full information for ISP implementation: Description of ISP connector

pins for currently selected chip, recommended target design around in-circuit programmed

chip and other necessary information.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 173 174

No comments

Dataman 40Pro User Manual Page 20