Dataman 40Pro User Manual download pdf (Page 38)

Multiprogramming by DATAMAN-48PRO2 /

DATAMAN-48PRO2C

During installation of PG4UW at Select Additional Tasks window you check, if is allowed

install DATAMAN-48PRO2 / DATAMAN-48PRO2C multiprogramming control support.

For start of DATAMAN-48PRO2 / DATAMAN-48PRO2C multiprogramming is necessary run

special control program pg4uwmc.exe. At this program user assign DATAMAN-48PRO2 /

DATAMAN-48PRO2C to control programs, may load projects for all DATAMAN-48PRO2 /

DATAMAN-48PRO2C and run PG4UW for every connected and assigned

DATAMAN-48PRO2 / DATAMAN-48PRO2C.

Selftest

If you feel that your programmer does not react according to your expectation, please run the

programmer (ISP connector) selftest using Diagnostic POD (Diagnostic POD for ISP

connectors #2), enclosed with the standard delivery package.

Selftest of programmer

 Insert 48 pins diagnostic POD - type I into ZIF socket of the programmer. 48 pins

diagnostic POD - type I must be inserted as 48 pins device.

 Run selftest of programmer in PG4UW (Programmer / Selftest plus).

Selftest of ISP connector

 Insert Diagnostic POD for ISP connectors #2 into ZIF socket of the programmer.

Diagnostic POD for ISP connectors #2 must be inserted as 48 pins device.

 Interconnect 20 pins connector of Diagnostic POD for ISP connectors #2 with an ISP

connector of the programmer with an ISP cable, included in delivery programmer

package. Be sure that pins are interconnected properly (i.e. 1-1, 2-2, ..., 20-20).

 Run selftest of ISP connector in PG4UW (Programmer / Selftest ISP connector…).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 173 174

No comments

Dataman 40Pro User Manual Page 38