Dataman 40Pro User Manual download pdf (Page 123)

PG4UW

123

The system is simple. For work with such devices it is necessary to have the Credit box

attached to PC where device programmer is attached. The Credit box is technically a small

dongle in USB port that contains some amount of credits, from 25 thousands to 500

thousands - depending on the model. The micropayment for each such device programming

is done by decreasing of credits amount in the Credit box.

The real fee for credit is very low, it starts at about 0.01 USD per credit for CB-25k version of

Credit box (= 25 thousands credits) and goes steeply down up to about 0.003 USD per credit

for CB-500k version of Credit box (= 500 thousands credits).

The validity of Credit box is limited to 10 regular versions of software. It means, once the

Credit box is activated at the time of first usage, it can be used by current and by next 9

regular versions of software.

Example: activated by 3.01 version of software can be used by 3.01, 3.02, ..., up to 3.10

version of software (including all OnDemand versions).

Credit box status is displayed in main window of PG4UW and PG4UWMC software.

See please the Application note Usage of Credit box for devices in 'Paid ISP support'

category at our web site for details.

Programmer / Module options

This option is used for multiple socket programmers for defining MASTER socket and activity

of each socket. MASTER socket group box allows user to set socket which is preferentially

used for device reading operation. Enable/Disable socket checkbox array allows user to set

enabling and disabling of each socket individually. Disabled sockets are ignored for any

device operation.

Programmer / Automatic YES!

This command is used for setting Automatic YES! mode. In this mode you just take off the

programmed device, then put new device into ZIF socket and a last operation will be

repeated automatically. Program automatically detects an insertion of a new device and runs

last executed operation without pressing any key or button. An insertion of device into ZIF is

displayed on the screen. Repeated operation executing will be cancelled by pressing key

<ESC> during waiting for insert/remove a device to/from ZIF.

After an operation with a device is executed, one of the OK or ERROR (status) LEDs on the

programmer will lights in dependence on the result of an operation and the BUSY LED will

blinking.

If the program detects removal of a device, then status LED will switched off, but the BUSY

LED will still blinking to indicate readiness of the program to repeat last operation with new

device.

After the program indicates one or more pins of (new) device in the ZIF socket of the

programmer, the BUSY LED will goes to light continually. From this the program will wait a

requested time for insert the rest pins of new device. If a requested time (Device insertion

complete time) overflows and a device is not correctly inserted, the program will lights the

ERROR LED to indicate this state. After new device was inserted correctly, the program will

switch off all status LEDs, except BUSY, and will start an operation with new device.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 173 174

Comments to this Manuals

No comments

Dataman 40Pro User Manual Page 123

Comments to this Manuals

Related products and manuals for Hardware Dataman 40Pro